#Pace 166 cb radio box movie
However I will point out in the movie the car obviously was a T top car and the antenna was right on the T bar roof in the center towards the back.which is by far the best place to put a CB antenna on a hardtop car. I worked at Pace back then and one of the engineers upstairs (Laslo Hirsch of 147. You do this by adjusting the height of the antenna until you get as low of an SWR across all the channels as you can. Thread starter J-RISH Start date Status Not open for further replies. You tune the antenna for the first and last channel of the radio, and then the middle. It will let your Pace CB 166 talk further and receive further than your Lil Wil can or will.Īs for your SWR question, yes you need to find a location for the antenna to sit, then you need to perform an SWR check using an SWR meter. A Wilson 1000 has a little over 5 ft and are very good antennas.in fact much better than the Lil Wil antennas you inquired about. However, it does look to me like it was probably a 5 foot whip. (The relay coil can be seen near Q11 on the schematic). You will have to determine if this circuit is similar. First off I don't know what antenna was used on the SATB Trans AM. I found an online schematic for the Pace 133 and143 which may have a typical relay coil switching arrangement used by Pace in figure 5-2.
0 kommentar(er)
